Fabric Strength Tester | Determination of Heavy Fabric Strength by Horizontal Strength Tester

strength is not good then it will break with excessive tensile force and thus the dresses produced may tear with the outside force. The strength of a fabric varies with EPI, PPI, and Count Variation. The strength of the fabric also varies if the length and width of the fabric to be tested is changed. The strength of the fabric also depends on the construction of the fabric. A plain fabric is stronger than a twill fabric if made from yarn of same count.

The m/c used here is a horizontal strength tester. Therefore, the experiment has two objects:

1. To find out the strength of the fabric.
2. To be precise in testing.

Theory:
Strength is a measure of the steady force necessary to break a material and is measured in pound. The m/c works in constant rate of extension principle. When the tension is high on the fabric then the fabric breaks.

Apparatus:
1. Heavy fabric.
2. Fabric strength tester.
3. Scissors.

M/c specification:
The Fabric Strength Tester
Goodbrand & Co. Ltd.
Capacity: 2000lb

Testing atmosphere:
Temperature – 29oC and relative humidity – 76%
Standard atmosphere: temperature – 20oC and relative humidity - 65%.

Sample:
Size – 6inch × 2inch.
No. of sample – 20 (For warp way-10, for weft way-10).

Working procedure:
1. At first 10inch × 2inch fabric was cut out from a big piece of fabric. The excess amount of fabric was cut because the two jaws will require at least 2inch each to grip the fabric. Thus 10 samples were cut down for testing warp way strength and 10 samples for weft way strength.
2. Now, the first sample is fixed with the upper jaw J1 and the lower jaw J2.
3. The m/c is started and observed the dial until the sample is torn out.
4. When the sample is torn out the m/c is stopped and the reading is taken.
5. By this way the others’ reading are taken.
6. At last average and CV% are calculated.

Data: